by chris1992 » Thu May 31, 2012 4:19 pm
Hi, I think I've fixed it, I drilled out the rivet holding the regulator, then replaced it with a new 9 volt regulator, the connections were the same, both gauges are working ( I think as they were?) I had about 1/4 tank of fuel when it stopped working and it's reading 1/4 now, the temp gauge seems a little low after running the engine for about 10mins , but the gauge moves. There is scope to adjust the needles so I guess I could "calibrate" them if I felt it necessary. The regulator I used was from Maplin, it's a TS 7809 CZ and the Maplin order No is N37CA 99p instead of Ford replacement £64 plus Vat. Hope this helps others.
Chris